OnTarget Blanks
Couldn't load pickup availability
1 x Tumbler
1 x Lid
1 x Steel Straw
1. Remove the plastic insert lid and straw.
2. Design your image and print it out on sublimation paper with sublimation ink printer.
3. Tape imaged sublimation paper onto tumbler.
4. Place and center the product inside the shrink film / sleeve.
5. Use heat gun on low setting to shrink the wrap to the contour of the product. Begin with the side away from the transfer first. Ensure the wrap only encases the sides of the product leaving top and bottom open.
6. Repeat above steps for each item to include in production run.
7. Set the convection oven at (329℉~338℉) for 4/5 minutes.
Examples of use are: can be sublimated, engraved, used with waterslide transfers, blinged, and epoxy
